A practical reference on deamidation: what it is, how it behaves, what the literature reports, and where the honest uncertainties sit.
Reviewed 2026-05-20. Anything still debated is marked as such rather than presented as settled.
Lyophilised material appears as a white to off-white cake or powder that is hygroscopic, and containers are usually equilibrated to room temperature before opening to limit condensation. Dissolution is performed in water, phosphate-buffered saline, or a mildly alkaline buffer, since solubility rises above neutral pH. Gentle inversion or low-speed mixing is preferred, because vigorous vortexing can promote surface denaturation and aggregation. Complete dissolution may require several minutes, and brief sonication is sometimes applied. Passing the solution through a 0.22 micrometre membrane removes particulates but does not by itself sterilise the liquid.
Storage at minus 20 degrees Celsius or lower in a desiccated container preserves the peptide for extended periods, while working solutions are commonly held at two to eight degrees Celsius for short intervals. Light exposure and repeated freeze-thaw cycles accelerate degradation, so dividing material into single-use aliquots is generally recommended. Adsorption to glass and plastic surfaces can lower the measured concentration of dilute solutions, particularly below one milligram per millilitre. The degradation routes most often reported for GLP-1 analogues are deamidation, methionine oxidation, and backbone hydrolysis. Relative rates under specific conditions are frequently described only for individual formulations.
Reverse-phase high-performance liquid chromatography with ultraviolet detection near 214 or 280 nanometres is widely used to assess purity and to resolve related impurities. Liquid chromatography coupled to mass spectrometry confirms identity through the protonated molecular ion and fragment ions formed in tandem experiments. Capillary electrophoresis and peptide mapping after enzymatic digestion supply complementary information on charge variants and modification sites. Circular dichroism and nuclear magnetic resonance can report on secondary structure in solution. Absolute quantification usually depends on an external standard, and reported purity depends on the detection wavelength and integration parameters chosen.
Semaglutide is a synthetic peptide analog of human glucagon-like peptide-1, developed by Novo Nordisk and first approved in 2017 for type 2 diabetes. It belongs to the incretin mimetic class, a group of agents that reproduce the glucose-dependent actions of endogenous GLP-1. The molecule was engineered to resist degradation by dipeptidyl peptidase-4 and to bind serum albumin, extending its half-life from minutes to roughly one week. Approval for chronic weight management followed in 2021, based on large cardiovascular and obesity outcome trials.
GLP-1 receptors are expressed on pancreatic beta cells, in the gut, and in several brain regions. Receptor activation raises cyclic AMP, enhances glucose-dependent insulin secretion, and suppresses glucagon release when blood glucose is high. Effects on gastric emptying and on hypothalamic appetite circuits reduce energy intake. Because insulin release remains glucose-dependent, the risk of hypoglycemia is low when the drug is used alone. The precise contribution of each pathway to body weight change in humans remains an area of active investigation.
| Property | Value | Notes |
|---|---|---|
| Purity assessment | RP-HPLC, 214 nm | Wavelength affects relative peak areas |
| Identity confirmation | LC-MS/MS | Precursor and fragment ion masses compared |
| Common degradation | Deamidation, oxidation | Amide and methionine residues are main sites |
| Working solution storage | 2-8 °C, short term | Longer holding favours frozen aliquots |
| Adsorption risk | Higher below 1 mg/mL | Glass and plastic surfaces both affected |
The semaglutide sequence is a 31-residue analogue of human GLP-1, altered at three positions relative to the parent hormone. Aminoisobutyric acid replaces alanine at position 8, arginine replaces lysine at position 34, and a lipophilic diacid is attached to lysine 26 through a short linker. These features are reported consistently in the structural literature. The position 8 substitution blocks recognition by dipeptidyl peptidase-4, while the attached chain drives strong, reversible association with a carrier protein in blood.
Receptor activation raises intracellular cyclic AMP through Gs coupling, which promotes glucose-dependent insulin release and suppresses glucagon secretion when blood glucose is elevated. Effects outside the pancreas include slower gastric emptying and altered appetite signalling in the hypothalamus and hindbrain. The relative contribution of each tissue to overall metabolic outcomes remains an area of active investigation. Central mechanisms in particular are inferred mainly from animal models and indirect human measures rather than direct observation.
As a peptide, semaglutide is sensitive to conditions that break amide bonds or modify side chains. Deamidation of asparagine and glutamine residues, oxidation of methionine and tryptophan, and non-covalent aggregation are the main degradation routes described in published stability work. Rate depends strongly on pH, buffer species, ionic strength, temperature and exposure to light. Formulators therefore choose a defined solution pH and often add excipients such as phosphate buffer, propylene glycol and phenol, each of which plays a separate role in pH control, tonicity or preservation.
Storage guidance for the finished injectable product distinguishes the unused state from the in-use state. Before first use, pens are kept refrigerated between 2 and 8 degrees Celsius, protected from light, and never frozen, since freezing can disrupt the peptide or the device. After first use, label instructions in several markets permit storage at room temperature up to about 30 degrees Celsius for a limited number of days. Solid research-grade material is normally held at or below minus 20 degrees Celsius, often with desiccant, and allowed to equilibrate before opening.
Quantification and purity assessment rely on separation methods coupled to optical or mass detection. Reversed-phase high-performance liquid chromatography resolves the intact peptide from related impurities and is the standard assay technique. Size-exclusion chromatography measures aggregates, while ion-exchange chromatography separates charge variants produced by deamidation. Mass spectrometry confirms identity and detects mass shifts of a few daltons. In biological matrices, liquid chromatography with tandem mass spectrometry is often used because immunoassays can cross-react with endogenous GLP-1 or with circulating fragments.
The sequence incorporates alpha-aminoisobutyric acid at position 8, replacing the alanine found in the natural hormone. This substitution blocks the primary DPP-4 recognition site and contributes most of the enzymatic stability. Albumin binding further protects the peptide and reduces the frequency of administration required to maintain active plasma levels. Because the fatty acid chain increases lipophilicity, the compound is formulated as a solution rather than a simple aqueous buffer. Researchers describe the design as an incremental optimization of earlier GLP-1 analogs rather than a wholly new scaffold.
Reported molecular weight is approximately 4113.6 daltons for the free base, and the peptide is supplied as a lyophilized powder or in buffered liquid form depending on the intended use. It is freely soluble in water when formulated with appropriate excipients, though the unconjugated peptide shows limited stability at neutral pH over long periods. Analytical characterization typically relies on reversed-phase high-performance liquid chromatography and mass spectrometry. Purity specifications for research-grade material commonly exceed ninety-five percent by area. Isotopic and impurity profiles differ between suppliers.
Two principal therapeutic variants exist under separate regulatory filings, one indicated for glycemic control in type 2 diabetes and one for chronic weight management. Both use the same active molecule; differences lie in formulation strength, titration schedule, and labeling. Regulatory agencies in the United States and European Union approved injectable forms in 2017 and 2018 respectively. An oral tablet formulation received approval later, using a carrier molecule to enhance absorption across the gastric epithelium. Labeling differs by jurisdiction and by indication.
After World War II the foundation sent a team to West Germany to investigate how it could become involved in reconstructing the country. They focused on restoring democracy, especially regarding education and scientific research, with the long-term goal of reintegrating Germany into the Western world. The foundation also supported the early initiatives of Henry Kissinger, such as his directorship of Harvard's International Seminars (funded as well by the Central Intelligence Agency) and the early foreign policy magazine Confluence, both established by him while he was still a graduate student. In 2021, Rajiv J. Shah, president of the Rockefeller Foundation, released a statement condemning eugenics and supporting the anti-eugenics movement. He stated that
=== United States === Under the FDA, the process of establishing evidence for vaccine clinical safety and efficacy is the same as for the approval process for prescription drugs. If successful through the stages of clinical development, the vaccine licensing process is followed by a Biologics License Application which must provide a scientific review team (from diverse disciplines, such as physicians, statisticians, microbiologists, chemists) and comprehensive documentation for the vaccine candidate having efficacy and safety throughout its development. Also during this stage, the proposed manufacturing facility is examined by expert reviewers for GMP compliance, and the label must have a compliant description to enable health care providers' definition of vaccine-specific use, including its possible risks, to communicate and deliver the vaccine to the public. After licensure, monitoring of the vaccine and its production, including periodic inspections for GMP compliance, continue as long as the manufacturer retains its license, which may include additional submissions to the FDA of tests for potency, safety, and purity for each vaccine manufacturing step.
Field desorption (FD) is a method of ion formation used in mass spectrometry (MS) in which a high-potential electric field is applied to an emitter with a sharp surface, such as a razor blade, or more commonly, a filament from which tiny "whiskers" have formed. This results in a high electric field which can result in ionization of gaseous molecules of the analyte. Mass spectra produced by FD have little or no fragmentation because FD is a soft ionization method. They are dominated by molecular radical cations M+. and less often, protonated molecules
Sources: en.wikipedia.org
== References == This article was submitted to WikiJournal of Science for external academic peer review in 2017 (reviewer reports). The updated content was reintegrated into the Wikipedia page under a CC-BY-SA-3.0 license (2018). The version of record as reviewed is: Mike Christie; et al. (2018). "Radiocarbon dating" (PDF). WikiJournal of Science. 1 (1): 6. doi:10.15347/wjs/2018.006. Wikidata Q55120317.
The findings were published after President Trump and Kennedy both claimed that paracetamol use during pregnancy was contributing to rising autism rates, urging women to avoid the common painkiller. Health experts and the World Health Organization rejected those claims, emphasizing that paracetamol remains the safest recommended medication for fever and pain relief during pregnancy, as untreated fever can pose serious risks to fetal development. Acetaminophen and paracetamol are the identical chemical drug compound. The name acetaminophen (brand name Tylenol) is commonly used in the United States while the name paracetamol (brand name Panadol) is commonly used in Europe and world wide.
where U is the elastic energy of the system and a is the crack length. Either the load P or the displacement u are constant while evaluating the above expressions. Irwin showed that for a mode I crack (opening mode) the strain energy release rate and the stress intensity factor are related by:
=== Origins === Chronic widespread pain had been described in the literature in the 19th century. Fibromyalgia was first recognized in the 1950s. Many names, including muscular rheumatism, fibrositis, psychogenic rheumatism, and neurasthenia had been applied historically to symptoms resembling those of fibromyalgia. The term fibromyalgia was first used in 1976, when Phillip Kahler Hench used it to describe widespread pain symptoms, and it was used by researcher Mohammed Yunus in a scientific publication in 1981. A 1977 paper on fibrositis by Smythe and Moldofsky was important in the development of the fibromyalgia concept. The first clinical, controlled study of the characteristics of fibromyalgia syndrome was published in 1981, providing support for symptom associations. In 1984, an interconnection between fibromyalgia syndrome and other similar conditions was proposed, and in 1986, trials of the first proposed medications for fibromyalgia were published. A 1987 article in the Journal of the American Medical Association used the term 'fibromyalgia syndrome', while saying it was a "controversial condition". The American College of Rheumatology (ACR) published its first classification criteria for fibromyalgia in 1990. Later revisions were made in 2010, 2016, and 2019.
Sources: en.wikipedia.org
Filtering removes particulate matter that can block columns or scatter light. A 0.22 micrometre membrane is typical, and the filter material should be checked for peptide adsorption.
Peptides can bind to glass and plastic, so a fraction of the material leaves the solution. The effect is proportionally larger in dilute samples and can bias quantitative results.
Reverse-phase high-performance liquid chromatography is the most widely reported approach. Purity figures should always be quoted together with the wavelength, gradient, and integration parameters used.
It is given either as a once-weekly subcutaneous injection or as an oral tablet taken once daily. The two forms use different absorption strategies, so they are not interchangeable on a milligram-for-milligram basis.